Author Topic: bits and bobs.  (Read 1720 times)

0 Members and 1 Guest are viewing this topic.

matt h

  • Jr. Member
  • **
  • Posts: 52
  • Karma: +7/-0
    • View Profile
bits and bobs.
« on: July 02, 2014, 07:31:16 PM »
I've started building a midi console, and was wondering if anyone had any of the following lying around.
Music desk hooks, thumb pistons, bench and a r/c pedal board.
I might think of other bits as I go along, but those seem to be the ones i'm struggling with.
regards,
Matt.

revtonynewnham

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 983
  • Karma: +67/-1
    • View Profile
Re: bits and bobs.
« Reply #1 on: July 03, 2014, 10:09:57 AM »
Hi

I have a 30 note straight flat pedalboard already fitted with a MIDI encoder (but needing switch contacts to be sorted properly) if that's any use.

Every Blessing

Tony

matt h

  • Jr. Member
  • **
  • Posts: 52
  • Karma: +7/-0
    • View Profile
Re: bits and bobs.
« Reply #2 on: July 03, 2014, 12:21:06 PM »
Tony,
Would you be bothered if I converted it to straight/ concave? The more I think about this pedal board the more I think it might be a good solution.
Regards
Matt.

revtonynewnham

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 983
  • Karma: +67/-1
    • View Profile
Re: bits and bobs.
« Reply #3 on: July 04, 2014, 09:46:11 AM »
Hi

You're welcome to it - at the very least it will give you the keys & springs, although a RC board might be far easier!  Just  let me know - I need to get it out of the way really.  A small contribution to the cost of the MIDI interface (Ron Coates supplied it) would be welcome - the board didn't cost me anything in the first place.  PM me if you want it (or ring).

Every Blessing

Tony

 


Locations of visitors to this page

Organ Design


Latroba Holidays