Organ matters - Organs matter!

Electronic Organs => Electronic Organs => Topic started by: kaspencer on February 28, 2021, 04:27:43 PM

Title: Electronic Stop Labelling for Hauptwerk
Post by: kaspencer on February 28, 2021, 04:27:43 PM
Good afternoon all!

I hope that the Moderators will not mind me posting this notice, but I am confident that it will be of interest to many Hauptwerk users.

There has been a lot of interest in the OLED Stop Labels which were shown on the photographs of my OPUS II organ on various sites (and on ( I agreed to release details of how this was done. I am pleased to say that there now exists a "Project Book" entitled "Electronic Stop Labelling for Hauptwerk Virtual Pipe Organs" and the booklet is available from me now.

Here is the front cover:

The booklet, in printed form only, describes how to mount up to 60 OLEDs (up to 120 on two Stop Jambs), and connect them to an Arduino Due, such that they can be incorporated into Stop Jambs with round or rectangular illuminated buttons of standard size.

To accompany this booklet, I have also made available one version of my Stop Labelling Software (known as "kasLABSv1.4x" either installed on your own Arduino Dues or on Dues which I can supply. This version uses OLED type SSD1306 - a Booklet and Software version for a different OLED (as used in the final version of my new console) may be released later.

Those who might be interested should contact me via the email address which is visible on the Cover Page (not by the messaging system please!).

Many thanks indeed ...

Kenneth Spencer